Japala writes “This is the project that I started to do something about these old and outdated mouse pads, maybe to add some more “glow” to them. I bought the plexi from a firm specialiced in plastics. They sell these surplus peaces priced by weight. I found this clear 500x500x5mm piece and payed 45 FIM for it (~$6).” [via] Link.
Joelsprayberry on Instructables writes “This is a DJ CD case turned upside down with 2 layers of hardibacker board (pegboard with no holes). I run an acoustic guitar through all of these pedals to create “live loops” so I needed to have an extremely quiet sound with no low hum or buzz. I ran George L’s audio cables and tons of 9volt power. I think this may be the most amount of pedals you can get into one space.” Link.
Nicrosin writes – “My Lexar JumpDrive gave out on me, I ended up fixing it (a piece was loose on the pcb) but destroyed the case in the process. So I found an Altoids Strips tin and used that for the case. Check out the set for the process.” Link.
Drew writes “If your vehicle was manufactured after 1996, it contains an On Board Diagnostic (OBD) computer that captures information about how it’s running. I’ve put together a basic HOWTO Guide for OBD-II so that you can get started playing with it. I use ScanTool‘s great hardware and GPL’d software for my setup. You can use it to save money by reading error codes without a trip to the mechanic when your “check engine” light is on, capture performance data about your car’s drivetrain in real-time, or log data as if it were an airplane’s “black box”.” Link.
Raph writes “Since the first time I saw a projection clock, I knew one day I would build my own by converting a watch with an LCD display. Last week, I bought a watch in a dollar store and managed to convert it to a projection clock. I can finally project the time on my bedroom ceiling.” Link.
Join the creators of MAKE magazine, the MythBusters, and thousands of tech DIY enthusiasts, crafters, educators, tinkerers, hobbyists, science clubs, students, and authors at MAKE’s first ever Maker Faire. All kinds of people who make amazing things in garages, basements, and backyards. Inspiration, Know-How, and Spirited Mischief-Making: Weird Science, Ultimate Garage, Robotics, Digital Entertainment/Gaming,Green Tech & Electronics Recycling, Ultimate Workshop MAKE: Remix Video Film Festival and more… I have a lot more to post about all this, but the site is live go check it out!! Link.
A few folks emailed about this, so here’s one I spotted – “This is a small wireless sensor platform providing a bluetooth SPP link to three axes of accelerometer data. The accelerometers are sampled by a PIC microcontroller (onboard ADC) at roughly 100Hz (rate can be changed via firmware). Data from the ADC conversion is sent to a remote computer using the PIC’s UART in conjunction with a drop-in bluetooth serial part. Even with two dual-axis accelerometers onboard there are up to 17 free I/O lines and two additional ADC channels depending on the device configuration. Three sockets provide access to all PIC signals. Over-the-air programming allows for easy firmware updates and rapid prototyping without the need to have a PIC programmer or special cable. Schematics, parts lists, and firmware sources are available online.” Link.
